DB9 Alloy Aluminum Rear Insert

D3D/STANDOFF  - IN STOCK

This is a one piece billet aluminum rear insert/trunnion for the DB9 Alloy.

Standoff Version/D3D, This fits the D3D Standoff version AND the SS. These do not use the standoffs but are threaded where the standoffs would be located, less hardware needed! This WILL work for Original DB9 Alloy.
The lower section of the insert is trimmed to fit SS kits. **This is the file version**

Hardware Included:
 8(pcs) M3-0.5 for using the D3D/SS Version on a Original style lower.

Made out of billet aluminum 6061, bead blasted then anodized black allowing for a textured black look. This matches very well with nylon carbon fiber filaments 

This is installed pretty easily. Have the side rails on the insert and slide the assembly directly down. The upper may need to be tapped into the insert for first install after it should be easy to remove and install

This requires NO special hardware. This is a drop in replacement

No Firearms are sold by Rutland Racing

The components purchased from Rutland Racing or "Rutland Group." are of a DIY nature. It is strongly recommended that these components are used by a qualified individuals. Rutland Racing is not responsible for any damages caused by misuses of our components.