X2 Modular Intake Kit

This new kit uses our new X2 Hood vent design. Uses a nut to keep the Vents installed and prevents the vent from moving. The Nut also necks down to accept a 1.5" duct, this ducting directs air and water to the front of the hull, from there a bilge picks up the water and the fresh air is delivered into the hull. All current vents (including my older version) sprays water everywhere inside the hull. Unfortunately, the left side vent is above the carburetors which poses a problem over time. This new design has a piece of frogzskin in between the vent base and the top vent style.

What is frogzskin? 
Long story short is a piece of mesh that is hydrophobic
See their website here : https://frogzskin.com

**************************

Air Intake Version : Just the vents with FrogzSkin and a bottom side Nut to hold vent down.

Air Down Version : Vents with FrogzSkin and a bottom side Flange nut to attach INCLUDED ducting

****************************

ASA Material. Which means these will be smoothed providing a non printed look